Sony KE-42M1 Operating Instructions (primary manual) Operating Instructions Manual page 7

Outdoor use
Do not install this mlit outdoors. If the unit is
exposed to rain it may result in fire or electric
shock. If the unit is exposed to direct sunlight
the unit may heat up and it may damage the
unit.
\\@
" L
Vehicle and ceiling
Do not install this tulit in a vehicle or hung
from the ceiling.
Bmnping of the vehicle may cause the set to
fall down and cause i111ury.
Ship and vessel
Do not install this trait m a ship or vessel. If the
unit is exposed to seawater, it may cause fire or
damage the unit.
AC power cord
b
Unplug the AC power cord when moving the set.
Do not move the set with the AC power cord plugged in. It may damage
the AC power cord and result in fire or electric shock.
Fall
Do not hang anything on the unit.
The unit may Pall from the stand or wall mount trait,
causing damage or serious inju13".
co;
Power-Cord Protection
Do not allow anything to rest on or roll over the
power cord. and do not place the set where the power
cord is stff'_iectto wear or abuse.
Antennas
Outdoor Antenna Grounding
If an outdoor antenna is installed, follow the precantions below. An
outdoor antemm system should not be located in the vicinity of overhead
power lines or other electric light or power circuits, or where it can come
in contact with such power lines or circuits.
WHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM,
EXTREME CARE SHOULD BE TAKEN TO KEEP FROM
CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT
WITH THEM IS ALMOST INVARIABLY FATAL.
Be sure the antelma system is grounded so as to provide some protection
against voltage surges and built-np static charges.
Section 810 of the National Electrical Code (NEC) in USA and Section
54 of the Canadian Electrical Code in Canada provides information with
respect to proper grmmding of the mast and supporting structure
grounding of the lead-in wire to an antenna discharge unit, size of
grounding conductors, location of antemm discharge unit connection to
grounding electrodes, and requirements for the grounding electrode.
Antenna Grounding According to the National
Electrical Code, ANSI/NFPA 70
'_ Antenna lead-in wire
_'/Ground clamp_
__------_/'z/ _"_ _E Antenna discharge unit
] Electric se_l / _ I(NEC Section 810-20)
] eauiDment _ ]._, /_.-_vl Grounding conductors
_--J_bJ,/_ (NEC Section 810-20)
Ground clamps
_..__/- Power service grounding
electrode system
(NEC Art 250 Part H)
NEC: National Electrical Code
Lightning
For added protection for this television receiver during a lighming storm.
or when it is left unattended and umlsed for long periods of time. unplug
it from the wall outlet and disconnect the antelma. This will prevent
damage to the receiver due to lightning and power-line surges.
(Continued7
7