NTP-A241 Provision G-Series Ports for Transponder Mode (Tx Mode)
Figure 6-15
To provision two-port unidirectional transponder mode
Step 6
Note
Click the Port A row (for example, Port 1).
a.
Uncheck Auto Negotiation. Ports cannot be provisioned in unidirectional transponder mode when
b.
autonegotiation is enabled.
In the TXP Port column, choose Port B (for example, Port 2) from the drop-down list.
c.
In the TXP Mode column, choose RX Only from the drop-down list. CTC completes the Port B TXP
d.
Port with Port A and TXP Mode with TX Only.
Click the Port B row and uncheck Auto Negotiation.
e.
Click Apply.
f.
The ports on the CTC card level view display arrows and a line between the back of the ports.
Cisco ONS 15454 Procedure Guide, R5.0
6-80
One-Port Bidirectional Transponder Mode
In
Step
6, "Port A" represents the first port in a pair and "Port B" the second port in the pair. You
can pair any two ports on a G-Series card in two-port unidirectional mode.
Chapter 6
Create Circuits and VT Tunnels
(Figure
6-16):
August 2005