Setting The Osdp Address For The Reader - Siemens AR50M-MF User Manual

Mullion Reader – User Manual
1
2
1. Connect the cables as shown in the table on the previous page.
2. Use this terminal to supply power to the readers.

10.2 Setting the OSDP address for the reader

The ACTpro 1500 controller automatically assigns an address to each reader. Therefore, Jumper 2 should
be removed for OSDP operation. The serial number of the reader is used to identify and enrol a reader on
the system . The serial number can be found on a sticker on the reverse of the front cover of the reader
(bordered in red in the image below).
© Siemens 2019
A,B,0V
+12/24V
30
Connecting the reader to ACT
A-100417-b
15.04.2019