ABB Ability 800xA Series User Manual page 63

3 Configuration
3.2 System Settings
Figure 3.9: Network Configuration Page
Enter the new IP configuration information.
• The Host Name is not pre-configured. It is not used and may therefore be left empty.
• IP Address and Subnet Mask must be present in any case.
• It is not necessary to configure a Default Gateway if the host and the Linking Device
share the same network.
When the entries are complete, click the Submit and Reboot button.
The input values are checked for consistency. In case of errors, the new network settings
are not accepted.
If you change the IP address of the Linking Device, the IP connection between PC
and Linking Device is lost. You have to use the new IP address to re-establish web
access to the Linking Device.
If all parameters are correct, the new values are accepted and displayed. The same
information will be displayed after clicking the Read Current Values button on the Network
Configuration page.
The Linking Device is rebooted after a few seconds and the new values are accepted,
see Figure
2PAA114135-610
3.10.
63