Annex - Philips System 21 Quick Operating Manual

12. ANNEX
0
0
•
0
• •
•
14
A summary of commands with descriptions is given below. The headings indicate
the functions to which the commands are related. The left column gives the
command level to which each command is applicable. In the following statements
given for P2000C and HP85, the commands shall be filled in in the place of "cmd"
except for the Group Execute Trigger and the Serial Poll commands where the
complete statements are given, because of the different command structure.
Defaults are given where applicable. The last column gives the section number
where the function is mentioned or handled in this Quick Operating ·Guide. Where
"Sys.M" is mentioned, it is referred to the System 21 manual; where "Op.Crd" is
mentioned, it is referred to the Operating Card of the slave. Where "~" is given in
the command syntax, a space-character is necessary for command recognition.
Where a space is given (for readability) , it is optional.
Default addresses
IEEE/IEC address of PM2101 11
Address switch in position 1.
Unit address of slaves
Command level
IEEE/IEC-interface
Master
Slave
Function I Command
Reset
"RES"
" RO"
"R1"
"R2"
nnO Address switch in position 0. nn
are the last 2 digits of PM-number.
Statement on P2000C Statement on HP85
IEC PRINT #11,"cmd" OUTPUT 711;"cmd"
IEC PRINT #11,"AID;cmd" OUTPUT 711;"AID;cmd"
IEC PRINt # 11,"AIDnnn;cmd" OUTPUT 711; "AIDnnn;cmd "
Description Default See
Sys.M
RESet the complete System 7
to the power-on conditions.
Reset unit as after power-on 7
Reset unit as after mode change .
Clear the block memory 8.3
of the unit.