Other Operations; Listening To The Radio; Preset Tuning/Manual Tuning; Listening To A Preset Station - Sony CMT-L7HD Primary Operating Instructions Manual

Presetting radio stations (continued)

Other operations

To
Tune in a weak
station
Cancel presetting
Change the preset
number
To change the AM tuning interval
(not applicable on the European
model)
The AM tuning interval is factory-preset to 9 kHz (or
10 kHz for some areas). To switch the AM tuning
interval, tune in any AM station first, then turn off the
system. Pressing and holding down FUNCTION,
turn the system back on. When you change the
interval, all the AM preset stations are erased. To
change back to the original interval, repeat the same
procedure.
Tips
• The preset stations are saved in the system's
memory for about a day even if you disconnect the
power cord or a power failure occurs.
• You can label the preset stations (see page 39).
• To improve the reception, adjust the supplied
antennas or connect an external antenna.

Listening to the radio

You can listen to a radio station either by
selecting a preset station or by manually tuning
in a station.

Listening to a preset station

— Preset Tuning
Preset radio stations in the tuner's memory first
(see "Presetting radio stations" on page 37).
1
Press TUNER/BAND to select "FM" or
"AM".
2
Press TUNING MODE on the remote
repeatedly until "PRESET" appears in
the display.
GB
38
Do this
Follow the procedure
described in "Setting presets
through manual tuning".
Press MENU/NO on the
remote in step 5 or 6.
Start over from step 1.
3
Press TUNING + or – repeatedly to
select the desired preset station (or
station name* or RDS station name**).
* The station name appears only if you have
labelled the station (see "Labelling the preset
stations " on page 39).
** European model only.
To select a desired preset number
using the numeric buttons on the
remote
Press numeric buttons instead of performing
step 3.
To enter preset number over 10, press >10 and
enter the corresponding digits. To enter 0,
press 10/0 instead.
Example:
To enter preset number 20, press >10, then 2 and
10/0.
Listening to a non-preset
radio station
— Manual Tuning
1
Press TUNER/BAND to select "FM" or
"AM".
2
Press TUNING MODE on the remote
repeatedly until "MANUAL" appears in
the display.
3
Press TUNING + or – repeatedly to tune
in the desired station.
Tips
• To improve the reception, adjust the supplied
antennas or connect an external antenna.
• If there is static during an FM broadcast, press FM
MODE on the remote until "MONO" appears in the
display. The broadcast will no longer be in stereo,
but the reception will improve.
• In step 2, press TUNING MODE on the remote
repeatedly until "AUTO" appears in the display,
and then press TUNING + or –. The frequency
indication changes and the scanning stops when the
system tunes in a station (Automatic Tuning).