Troubleshooting - Beko BCT9031G User Manual

l■uvl,:•1111:ffllllllnliffl::■,il,l,jfillu::@Bll:Bllina~
• When the metal parts are heated, they may expand and cause noise.»>
This is not a fault.
l■lllllnllilill~
• The mains fuse is defective or has tripped. »>
Check fuses in the fuse box. If necessary, replace or
reset them.
• Product is not plugged into the (grounded) socket. »>
Check the plug connection.
• If the display does not light up when you switch the hob on again. »>
Disconnect the appliance at the
circuit breaker. Wait 20 seconds and then reconnect it.
• Overheat protection is active. »>
Allow your hob to cool down.
• The cooking pot is not suitable. » >
Check your pot.
1~,!llBl■,lliDl■l ■ l1llliililn1IHIII~
• You have not placed the pot on the active cooking zone.>>> Check if there is a pot on the cooking zone.
• Your pot is not compatible with induction cooking. »> Check if your cooking pot is compatible with
induction hob.
• The cooking pot is not centered properly or the bottom surface of the pot is not wide enough for the
cooking zone. >>> Choose a pot wide enough and center the pot on the cooking zone properly.
• Cooking . . . . pot or cooking zone is overheated. >>> Allow them to cool down.
lelmB iiill!ni i■iiillii!ilirniillirlnllQfiirillin!!
• Cooking time for the selected cooking zone may be over.>>> You may set a new cooking time or finish
cooking.
• Overheat protection is active. >>> Allow your hob to cool down.
• An object may be covering the touch control panel. > > > Remove the object on the panel.
■nlilil■inlll ■■ RinllllRllllll■ililn~
• Your pot is not compatible with induction cooking. »> Check if your cooking pot is compatible with
induction hob.
• The cooking pot is not centered properly or the bottom surface of the pot is not wide enough for the
cookin zone. >>> Choose a pot wide enou hand center the pot on the cooking zone properly.
Consult the Authorised Service Agent or
echnician with licence or the dealer where you
1 ___ ,have purchased the product if you can not
remedy the trouble although you have
implemented the instructions in this section.
Never attempt to repair a defective product
yourself.
23/EN