Specifications - Sony PCM-M1 Operating Instructions Manual

Specifications

Tape
Recording time
Sampling frequency
Quantization
Frequency response
(during playback)
Signal to noise ratio
Dynamic range
Total harmonic distortion
Wow and flutter
Input
MIC/LINE IN
Output
Jack type
LINE OUT
REMOTE/2 stereo minijack 16 ohms
Input/Output
Power requirements
Battery life
Power consumption
Dimension
Mass
52 EN
Additional Information Additional Information
Digital audio tape
Standard: 120 minutes
Long-play mode: 240 minutes (with DT-120)
48 kHz, 44.1 kHz, 32 kHz
Standard: 16-bit linear
Long-play mode: 12-bit non linear
Standard: Fs 48 kHz 20-22,000 Hz (±1.0 dB) (LINE IN)
Fs 44.1 kHz 20-20,000 Hz (±1.0 dB) (LINE IN)
Fs 32 kHz 20-14,500 Hz (±1.0 dB) (LINE IN)
Long-play mode: Fs 32 kHz 20-14,500 Hz (±1.0 dB) (LINE IN)
Standard: more than 87 dB
Long-play mode: more than 87 dB
(1 kHz IHF-A, LINE IN)
Standard: more than 87 dB
(1 kHz IHF-A, LINE IN)
Standard: less than 0.008% (1 kHz, 22 kHz LPF, LINE IN)
Long-play mode: less than 0.09% (1 kHz, 22 kHz LPF, LINE IN)
Below measurable limit (less than ±0.001% W.PEAK)
Jack type
stereo minijack
Impedance
stereo
220 ohms
minijack
REMOTE•DIGITAL I/O jack (special jack)
Digital input/output, remote control operation and timer-activated
operation is possible by connection with an adaptor kit to this jack.
• Two R6 (size AA) alkaline batteries (not supplied)
• Two nickel metal hydride rechargeable battery (supplied)
DC IN 4.5 V jack accepts:
the Sony AC power adaptor AC-E45HG (supplied)
the car battery cord DCC-E245 (not supplied) for use with 12V/24V car
battery.
See "Replacing the batteries" (page 40).
0.9 W
Approx. 80 x 117.3 x 29.2 mm (3
parts and controls
Main unit: Approx. 290 g (10.3 oz.)
When using the main unit: Approx. 395 g (14 oz.) incl. headphones with
remote control, rechargeable batteries and a cassette
Impedance Rated input level
MIC MIC
4.7 kilohms 1.4 mV
LINE IN LINE IN
47 kilohms 500 mV
Rated output Maximum output level
500 mV
87mV 15 mW + 15 mW
1 5 3
⁄ x 4 ⁄ x 1
4 8
Minimum input level
MIC
0.3 mV
LINE IN
120 mV
Load impedance
—
10 kilohms
16 ohms
⁄ in) (w/h/d) not incl. projecting
16