Bosch ACS 561 Repair Instructions page 15

ACS 561 Service Manual
Edit Print Header
If the optional printer is installed, changes to
the printed text can be made. To make changes
to the text appearing in the header on each
printout:
1. Select EDIT PRINT HEADER from the
Setup menu.
2. The cursor should be blinking in the first
field. Press the Menu key to display a virtual
keyboard.
3. Use the arrow keys to move around the
keyboard. Press F1 to enter a character.
4. Press the Menu key to exit the keyboard
and move to the next fill field.
5. Press the F2 key to exit the keyboard.
For more information about the text edit feature,
refer to the User Guide under the Edit Print
Header.
Power Lockout/Tagout Switch
Never leave the machine live if an immediate
use is not scheduled. To ensure that unauthor-
ized personnel cannot run the machine, use the
Lockout / Tag Out feature.
1. Turn the Lockout / Tagout lever counter-
clockwise (CCW).
2. Insert a padlock or other item through the
aligned holes so the lever cannot be turned
clockwise (CW) to start the machine.
Robert Bosch GmbH
Introduction
Calibration Check
This function is used to ensure the machine's
internal scale is always calibrated. During this
test, use only the calibration weight that is pro-
vided with the machine.
1. Select CALIBRATION CHECK in the Setup
menu. The machine displays
PLACE SAMPLE WEIGHT ON SCALE
START
2. Refer to Figure 1-7, and verify the magnet
on the bottom of the machine is clean.
3. Attach the calibration weight to the magnet
on the bottom of the machine. Select F1.
• If the display shows
PROCEDURE COMPLETED
the scale is in calibration. Select F1.
• If the display shows
CALIBRATION REJECTED!
the scale is out of calibration. refer to the
Replacement Scale/Assembly Magnet in
the Electrical section and perform a Scale
Calibration followed by an upper limit
Calibration.
Calibration Check
Figure 1-7. Calibration Check
15
EXIT
SP00D00517 2018-07-11