D-Link DAP-1610 Quick Install Manual page 4

There are two easy ways to set up your Range Extender.
It is recommended that you use Method One. If your router does not have
a WPS button (
Method One: Quick WPS Setup
Plug your Range Extender into an available outlet
1
near your wireless router and wait until the
Status LED is blinking amber (this may take up
to 3 minutes). You can move it to a more suitable
location after it is set up.
Press the WPS (Wi-Fi Protected Setup) button on
2
your wireless router for 3 seconds. Look for the
WPS light ( ,
it is blinking. If it does not blink, see the important
note below.
IMPORTANT
WPS may be disabled on some Routers or Modems.
If the WPS Status LED on your Router or Modem
does not start blinking when you have pressed the
WPS button, try again and hold it a little longer. If
it still does not blink, STOP, and configure your
Range Extender using Method Two: QRS Mobile
Once confirmed that the WPS light is blinking on
3
your router, within one minute, press the WPS
button on your Range Extender for 2-3 seconds.
The Status LED should start to blink green.
4
, ), see Method Two: QRS Mobile Setup, on page 6.
) on your router and make sure
Setup, on page 6.
WPS PS
DAP-1610 Install Guide