Table of Contents
Advertisement
Installation
Flush-fit installation
Create the worktop cut-out.
Remember to maintain the minimum
safety distances (see "Safety
distances").
Solid wood, tiled and glass worktops:
Fix a wooden frame 7 mm below the
top edge of the worktop.
Risk of damage from incorrect
connection.
The hob electronics may be
damaged if a short-circuit occurs.
The mains connection cable must be
connected to the hob by a qualified
electrician.
Connect the mains connection cable
by following the instructions in the
wiring diagram on the hob (see
"Electrical connection" – "Wiring
diagram").
Stick the supplied sealing strip under
the edge of the hob. Do not apply the
sealing strip under tension.
Feed the mains connection cable for
the hob down through the worktop
cut-out.
Centre the hob in the cut-out.
The gap between the ceramic surface
and the worktop must be at least
2 mm wide. This is required so that
the hob can be sealed.
Connect the hob to the mains (see
"Electrical connection").
Check that the hob works.
76
Seal the gap between the hob and
worktop with a silicone sealant that is
heat-resistant to at least 160 °C.
Damage from unsuitable sealant.
Unsuitable sealant can damage
natural stone.
For natural stone worktops and
natural stone tiles, only use silicone
sealant that is specially formulated
for natural stone. Follow the
manufacturer's instructions.
Hide quick links:
Advertisement
Table of Contents
