Settings Required When Connecting An External Editing Control Unit; Timecode Settings On This Unit; Settings On Editing Control Units - Sony DSR-2000P Operating Instructions Manual

Settings Required When Connecting an External
Editing Control Unit
When connecting an external editing control unit to
this unit and using this unit as a recorder, make the
following timecode settings on this unit and VCR
constant and DIP switch settings on the editing control
unit.

Timecode Settings on This Unit

Make the following time code settings for this unit.
Control
INT/EXT–PRESET/REGEN
switch
FREE RUN/REC RUN switch FREE RUNswitch

Settings on Editing Control Units

Make the following settings according to the editor
model.
For FXE-100/120 (NTSC)
Set the VCR constants as follows.
Byte No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Setting 80 14 00 96 05 05 03 80 0A 08 FE 00 80 5A FF
For FXE-100P/120P (PAL)
Set the VCR constants as follows.
Byte No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Setting 81 14 00 7D 05 05 02 80 0A 07 FE 00 80 4C FF
For BVE-910/2000
Set the VCR constants as follows.
• When using the DSR-2000 (NTSC)
Byte No. Block 1
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Setting 80 14 00 96 05 05 03 80 0A 08 FE 00 80 5A FF
• When using the DSR-2000P (PAL)
Byte No. Block 1
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Setting 81 14 00 7D 05 05 02 80 0A 07 FE 00 80 4C FF
130
Chapter 7 Connections and Settings
Setting
INT–PRESET (right position)
Block 2
Block 2
For RM-450 (NTSC)
Set the VCR constants as follows.
• Left DIP switch
Switch No. 7 6 5
Setting OFF — —
• Right DIP switch
Switch No. 7 6 5
Setting OFF — OFF ON
For RM-450CE (PAL)
Set the VCR constants as follows.
• Left DIP switch
Switch No. 7 6 5
Setting OFF — —
• Right DIP switch
Switch No. 7 6 5
Setting ON — OFF ON
For BVE-800
Set the VCR constants as follows.
When using the DSR-2000 (NTSC)
• SW2
Switch No. 1 2 3
Setting ON OFF ON
• SW3
Switch No. 1 2 3
Setting ON ON ON
When using the DSR-2000P (PAL)
• SW2
Switch No. 1 2 3
Setting ON OFF ON
• SW3
Switch No. 1 2 3
Setting OFF OFF OFF ON
For PVE-500
Use the factory settings as they are.
4 3 2 1 0
OFF — — — —
4 3 2 1 0
OFF OFF ON ON
4 3 2 1 0
OFF — — — —
4 3 2 1 0
OFF OFF ON ON
4 5 6 7 8
ON — ON ON —
4 5 6 7 8
OFF — ON OFF OFF
4 5 6 7 8
ON — ON ON —
4 5 6 7 8
— ON OFF OFF