Siemens SIMATIC NET SCALANCE S615 Operating Instructions Manual page 23

● Reset to factory defaults
– Hold down the button until the red fault LED (F) stops flashing after approximately 10
– Now release the button and wait until the fault LED (F) goes off again. The device then
You will find more information in the section "Service and Maintenance" in the
SCALANCE S615 Web Based Management configuration manual.
EXPLOSION HAZARD
Do not press the SET button if there is a potentially explosive atmosphere.
SCALANCE S615
Operating Instructions, 08/2018, C79000-G8976-C389-04
seconds and is permanently lit.
starts automatically with the factory settings and can be reached via the IP address
192.168.1.1.
WARNING
Description of the device
2.6 SET button
23