Installing On The Din Rail - Siemens SIMATIC NET SCALANCE S615 Operating Instructions Manual

3.4

Installing on the DIN rail

Installation
1. Place the third housing guide of the device on the top edge of the DIN rail
2. Press the device down against the DIN rail until the spring catch locks in place
3. Connect the power supply, refer to the section "Power supply (Page 39)".
4. Fit the connectors for the digital input and digital output, refer to the section "Digital
input/output (Page 42)".
5. Connect the device to the local network, refer to the section "Ethernet port (Page 45)".
6. Connect the terminal with as short a cable as possible ≤ 150 mm and a large cross-
sectional area of 1.5 mm² to the functional ground of the system, see section "Terminals
(Page 18)" and section "Grounding (Page 41)".
7. Also connect the DIN rails of a system with functional ground.
Dismantling
1. Disconnect all connected cables.
2. Using a screwdriver, pull down the catch on the rear of the device.
3. Pull lower part of the device away from the DIN rail.
SCALANCE S615
Operating Instructions, 08/2018, C79000-G8976-C389-04
Installation
3.4 Installing on the DIN rail
①
.
②
.
29