Controlling Other Tvs With The Remote Commander - Sony EZ77NZ Operating Instructions Manual

Notes
• The TV/VIDEO button selects an input source of the TV from either aerial in or line
in. The button does not control this VCR.
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove
the batteries to avoid possible damage from battery leakage.
• Do not use a new battery with an old one.
• Do not use different types of batteries.

Controlling other TVs with the remote commander

The remote commander is preprogrammed to control non-Sony TVs. If your
TV is listed in the table below, set the appropriate manufacturer's code
number.
1
Set TV / VIDEO at the top of the remote commander to TV .
2
Hold down ?/1, and enter your TV's code number(s) using the
programme number buttons. Then release ?/1.
Now you can use the ?/1, VOL +/–, PROG +/–, programme number
buttons, ? (ten's digit) and TV/VIDEO buttons to control your TV. You
can also use the buttons marked with a dot (•) to control a Sony TV. To
control the VCR, reset TV / VIDEO to VIDEO .
Code numbers of controllable TVs
If more than one code number is listed, try entering them one at a time until
you find the one that works with your TV.
Manufacturer Code number
1
Sony 01*
Akai 68
Blaupunkt 10
Ferguson 52
1
Grundig 11*
Hitachi 24
ITT/Nokia 15,16,69*
JVC 33*
Loewe 45
Mivar 09, 70
NEC 66
1
Panasonic 17*
,02
3
,49
Manufacturer
Code number
1
Philips 06*
Saba 12,13
Samsung 22,23
Sanyo 25
Sharp 29
Telefunken 36
Thomson 43* 2
Toshiba 38
1 1
,07* ,08*
continued
7
Getting Started