Page 1
Part HW001632A01 Part 08-04-02-538LF Part 08-04-02-540LF Camera Base 2. Configure Sr600 In-Car Video Camera for Use Installation 2.1 Welcome! Please begin by referring to your Motorola 2.2 Press and hold the Power/Record button to turn on the CommandCentral Admin documentation to access the software camera and wait about 30 seconds.
Page 2
2.5 Make sure the camera is in range of the Wi-Fi network should now be blinking red, green and blue: scan it with the Sr600 within five minutes. You must generate a specified by CommandCentral Admin. Hold the camera still.
Page 3
3. Sr600 In-Car Video Camera and Base Connector Interface 4. Sr600 Camera and Base Installation 3.1 Windshield mount camera base - 16-PIN Automotive 3.2 Sr600 In-Car Video Camera - 6-PIN Interface Connector + 4.1 Peel off one side of adhesive disc (either side). Carefully ®...
Page 4
4. Sr600 In-Car Video Camera and Base Installation 4.5 Your Sr600 In-Car Video Camera will record a 360° 4.6 With the Sr600 In-Car Video Camera snapped into its base 4.7 Once the location of the assembly is satisfactory, mark the ®...
5. Wiring Diagram 6. Installing the Sr600 In-Car Video Camera 5.1 Now it’s time to route the cable assembly to the vehicle 6.1 After routing the wire harness to the junction box, ensure 6.2 Attach the camera base into the RAM® Mount installed on junction box and connect the wires per the wiring diagram.
Page 6
In this case additional wire (not supplied) may be required to connect the trigger lines on the Sr600 cable kit to the required triggers in the vehicle. Multi-conductor wire of at least 22 gauge may be used to make these connections.