・DISPOSAL OF OLD EQUIPMENT DISCLAIMER OF LIABILITY CUSTOMER SERVICES Thank you for choosing Panasonic photovoltaic module HIT “HIT” is a trademark of the Panasonic Group. Please read this manual completely before you install or use Other product and service names listed in this .
vices such as ground fault, fuses, Do not puncture or damage the installed by Panasonic. There are no and disconnects may be required. back sheet of a module. Do not use user serviceable parts within the the PV module and make a replace- ...
perature, AM1.5 and solar spectral ratings, conductor capacities, fuse MODULE SPECIFICATIONS irradiance according to IEC 60904- sizes, and size of controls connect- Module specifications are shown in ed to the module output. Table 1 and Figure 1. (Electrical Under normal conditions, a mod- The current output for the mod- specifications, mechanical specifi- ule may experience conditions that...
Page 4
Dimensions in mm Side Back side Front side * The positions of the holes are all symmetrical against the center of the module. Section A-A’ Section B-B’ Enlarged view Note) A module is installed using 4 points, symmetrical mounting within setting range (shaded). Setting range parameters are shown in “Mount Locations and Load Resistance”...
produce flying brands. heating and array current reduc- STANDARDS tion. JUNCTION BOX AND TERMINALS VBHNxxxSJ53 series comply with the All modules are equipped with fac- requirements of IEC61215, IEC61730-1, Modules equipped with one junc- tory installed bypass diodes. The IEC61730-2 and the CE mark.
Conditions. An installation location with conditions beyond the Operating Condi- tions or with other Special Conditions (see below) should be avoided. Operat- ing Conditions of Panasonic modules are as follows: Figure 4. Fixing of cables 1) The modules should be operated only and connectors in terrestrial applications.
Clearance of 100mm between the Please contact your Panasonic Au- steeper than the water gradient. roof surface and module frame is thorized Representative with ques- required to allow cooling air to cir-...
Use copper wire which is insulated Ground wire (5.5mm , green) Ground hole Please contact your Panasonic Au- to withstand the maximum possible thorized Representative with ques- system open circuit voltage. For Flat washer (stainless steel) Spring washer (stainless steel)
In order to maintain optimum out- acid detergent detergent accepted by Panasonic unless prior writ- put of the module, quality and safe- which forms a protective layer on ten authorization has been given by ty, please conduct periodic inspec- the surface of the glass to clean any Panasonic.