GE Baker Hughes Masoneilan SVI FF Installation And Operation Manual page 84

Removing the SVI FF Display Cover
To remove the SVI FF display cover:
1. Using a 5 mm Hex key unscrew the four screws around the perimeter of the SVI FF cover.
2. Lift the cover off the positioner.
Pneumatic
Cover
Installing the SVI FF Display Cover
NOTE
The replacement display cover is shipped with a lanyard to prevent the cable (that connects
from the display to the Terminal Board) from breaking. The lanyard must be inserted under the
screw in the lower left corner, that attaches the terminal board to the SVI FF housing.
To install the cover:
1. Install the lanyard and tighten the screw to 5 in-lbs (.565 N-m).
2. Using the 3 mm hex key, remove the screw from the lower left corner, connecting the
terminal board to the SVI FF housing.
3. Connect the cable from the display into the LCD connector on the terminal board.
4. Ensure that the gasket is in its groove in the housing.
5. Place the cover over the screw mounts.
84 |
BHGE
Figure 41 SVI FF Display and Pneumatic Covers
After replacing the SVI FF Display Cover you must power up the
unit (see "Power Up the SVI FF" on page 78 of this guide).
Display
Cover
© 2019 Baker Hughes, a GE company, LLC. All rights reserved.