Helical Interpolation (G02, G03) - Siemens Sinumerik 840D sl Programming Manual

2.1.5

Helical interpolation (G02, G03)

With helical interpolation, two motions are superimposed and executed in parallel:
● A plane circular motion on which
● A vertical linear motion is superimposed.
Figure 2-6
ISO Milling
Programming Manual, 06/09, 6FC5398-7BP10-1BA0
Helical interpolation
Note
G02 and G03 are modal. The circular motion is performed in those axes that are defined
by the specification of the working plane.
For detailed description of the interpolation parameters in case of helical interpolation,
refer to "Programming Manual Fundamentals".
Drive commands
2.1 Interpolation commands
25