Siemens Sinumerik 840D sl Programming Manual page 29

Programming in operation with cylindrical interpolation
Only the following G functions can be used in cylindrical interpolation: G00, G01, G02, G03,
G04, G40, G41, G42, G65, G66, G67, G90, G91 and G07.1. In operation with G00 only
those axes can be used that are not involved at the cylindrical plane.
The following axes cannot be used as a positioning axis or a reciprocating axis:
1. The geometry axis in the peripheral direction of the surface of the cylinder (Y axis)
2. The additional linear axis for groove side offset (Z axis)
Relations between the cylindrical interpolation and operations with reference to the coordinate system
● The functions mentioned below should not be used in operation with cylindrical
● The relevant overrides (rapid traverse, JOG, spindle speed) are effective.
● On deselecting this operation with cylindrical interpolation, the interpolation plane that
● To perform the tool length compensation, the command for the tool length compensation
● The work offset (G54 - G59) is also to be written before specifying the G07.1 command.
ISO Milling
Programming Manual, 06/09, 6FC5398-7BP10-1BA0
interpolation.
– Mirroring
– Scaling (G50, G51)
– Rotation of the coordinate system (G68)
– Setting the basic coordinate system
was selected before the operation with the cylindrical interpolation was called becomes
active again.
is to be written before specifying the G07.1 command.
Drive commands
2.1 Interpolation commands
29