Electrical Connection - Miele PWD 8545 MD Operating Instructions Manual

3.2

Electrical connection


The machine must only be operated at the voltage, frequency and fuse rating shown on the
data plate.

Check that the power supply voltage is within a range of +/-10% of its nominal value.

The frequency of the power supply voltage should not differ by more than 1% of its
nominal value.

The electrical safety of the machine can only be guaranteed when correctly earthed.
Equipotential bonding is required.

Ensure that electrical systems are effectively earthed.

The earth conductor should be connected to the earth terminal
identified by the standard symbol.

If the machine is hard wired to the power supply, connection
should be made via a mains switch with all-pole isolation. The main
switch must be designed to operate at the rated current.

For increased safety, it is recommended to protect the machine with a suitable residual
current device (RCD) with a trip current of 30 mA (DIN VDE 0664).

The machine should be disconnected from the power supply when not used for prolonged
periods.

The power supply on site must be sufficient in cross-section and protected in accordance
with current local regulations.
REV.0.00_COD.223130_A4
ATTENTION
All electrical work must be carried out by a suitably qualified and competent
person in accordance with local and national safety regulations.
INSTALLATION
Page 13