Setting The Volume - Silvercrest SSR 10 A2 User Manual

Briefly press the "On/Standby" button (6) again to switch off the
scan radio. "OFF" is indicated briefly on the display (1), followed
by the time currently set.

Setting the volume

You can set the device volume to a value between "00"
(minimum volume) and "15" (maximum volume). The setting upon
delivery is "4".
Proceed as follows:
Press the "-" button (2) or "+" button (4) in radio mode to
decrease or increase the volume. The "VOLUME" indicator (21)
also appears on the display.
If the volume reaches level "04", the volume warning symbol
(17) starts to flash on the display. Now you can continue to
increase the volume only if you have confirmed the volume
warning in advance by briefly pressing the "MODE" button (3).
The display indicates the volume level currently set. If no button is
pressed for approx. 3 seconds, the currently tuned frequency
appears on the display again. If the device is set to a value
between "5" and "15" when it is switched off, the scan radio
starts at volume "4" when it is switched on again.
The setting has no effect on the volume of the buzzer
for the alarm clock function. The buzzer volume is
always the same.
SilverCrest SSR 10 A2
English - 15