Monitor Performance
Performance monitoring (PM) parameters are used by service providers to gather, store, and report
performance data for early detection of problems. For more PM information, details, and definitions,
refer to the Cisco ONS 15310-MA SDH Reference Manual. This chapter explains how to enable and view
PM statistics for the Cisco ONS 15310-MA SDH.
Before You Begin
Before performing any of the following procedures, investigate all alarms and clear any trouble
conditions. Refer to the Cisco ONS 15310-MA SDH Troubleshooting Guide as necessary.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
6.
Note
For additional information regarding PM parameters, refer to Telcordia's GR-1230-CORE,
GR-499-CORE, and GR-253-CORE documents and GR-820-CORE document titled Generic Digital
Transmission Surveillance, and in the ANSI T1.231 document entitled Digital Hierarchy - Layer 1
In-Service Digital Transmission Performance Monitoring.
78-19416-01
NTP-H64 Change the PM Display, page
NTP-H65 Monitor Electrical Performance, page
NTP-H66 Monitor Optical Performance, page
NTP-H67 Monitor Ethernet Performance, page
NTP-H68 Create or Delete Ethernet RMON Thresholds, page
NTP-H175 Enable or Disable AutoPM, page
C H A P T E R
7-2—Complete as needed.
7-3—Complete as needed.
7-4—Complete as needed
7-4—Complete as needed.
7-6—Complete as needed.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
7
7-5—Complete as needed.
7-1