Chapter 9
Change Port Settings
Click the Provisioning tab.
Step 3
Click the Ether Ports or POS Ports subtabs and complete the following:
Step 4
PSAS—Check to enable Pre-Service Alarm Suppression (PSAS), which suppresses all alarms on the
•
port for the time designated in the Soak Time column.
Soak Time—Choose the desired soak time (in hours and minutes). Use this column when you have
•
checked PSAS to suppress alarms. Once the port detects a signal, the countdown begins for the
designated soak time. Soak time hours can be set from 0 to 48. Soak time minutes can be set from
0 to 45 in 15 minute increments.
Click Apply.
Step 5
Stop. You have completed this procedure.
78-19416-01
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
9-5