Hard Disk Drive - Mitsubishi Electric apricot XEN-LS II Using Setup And Installing Add-Ons

3.5" hard disk drive

The XEN-LS II supports one 1.6" high or two 1" high, 3.5"
hard disk drives.
Preparation
To install a hard disk drive you must first remove the 3.5"
drive bay:
1. Power the system down.
2. If there is a diskette in the 3.5" floppy drive, remove it.
3. Take suitable anti-static precautions and remove the
system unit cover.
If you are unfamiliar with Apricot's recommended anti-
static precautions and/or the process of removing the
system unit cover refer to your Owner's Handbook .
In order to remove the 3.5" drive bay you must first remove
the 5.25" drive bay.
4. If there is a drive fitted in the 5.25" bay disconnect
the power and signal cables from the rear of the
drive.
48
5.25" BAY
SECURING SCREWS