Installing In Kitchen Furniture Unit - Miele 7080 850 Operating And Installing Instructions

12
Installing in kitchen furniture unit
Do not install the appliance near a heater or cooker.
Check kitchen unit interior dimensions against those shown
in the illustration.
Align the kitchen unit with a spirit level and a try square; if
necessary, place packing underneath until the unit stands
squarely. The intermediate shelf must be at a right angle to
the side panel of the kitchen unit.
For ventilation (air inlet and outlet paths), a vertical gap at
least 38 mm deep must be provided at the back of the appli-
ance.
Air inlet cross-section A: at least 200 cm2. Air must enter
through the plinth screen panel of the kitchen unit.
Check position of power socket
CD.
The power supply type
(AC) and voltage where the appliance is used must agree Fig. A
with the data on !he type plate.
The type plate is on the left inside wall, next to the vegetable
bins. Allow the appliance to stand for about 1/2 to 1 hour after
transport, before connecting to the power supply. The appli-
ance must be connected to the mains power supply by
means of a properly earthed power socket and plug.
24
0
0
...-
('I)
C\J
...-
CX)
x
1"-
1"-
1"-
I
ca
C\J
E
1"-
1"-