Installation - Huawei VPC620 Manual

No. Port
8
3G-SDI port
9
COM OUT port
10
COM IN port
11
Power port
12
Power button

Installation

The VPC620 or VPC600 can be mounted on top of a display (such as TV set and monitor),
wall-mounted, ceiling-mounted, or placed horizontally.
If the display is thicker than 170 mm or the display is wall-mounted, the VPC620 or VPC600
can be installed in any possible way other than be mounted on top of the display.
If the display is 170 mm or thinner, the VPC620 or VPC600 can be mounted on top of a
display or placed horizontally.
Placed Horizontally
Mounted on Top of a Display
Functions as a bayonet-neill-concelman (BNC) connector to
output 3G-SDI and HD-SDI signals.
3G = 3rd Generation
HD = high definition
SDI = serial digital interface
The VPC600 does not have this port.
Cascades a lower-level camera. This port complies with the
Video System Control Architecture (VISCA) standard.
VISCA is a trademark of Sony Corporation.
Functions as a serial port to connect to an HD videoconferencing
endpoint or cascades with an upper-level camera. In addition,
this port can be used to upgrade the camera.
Functions as a 12 V DC power input port.
Powers the camera on or off.
This button is valid when the camera is connected to a power
adapter and is not used with the TEX0 series videoconferencing
endpoint.
Place the camera on a flat surface.
If you have to place the camera on a sloping surface,
ensure that the slope is less than 15° or the camera may not
function properly.
Use the L-shaped bracket to secure the VPC620 or
VPC600 on top of the display. The following figure shows
the installation procedure.
3
Description