Connecting A Terminal To The Rs-232 Ports - HP 744 Owner's Manual

Connecting a Single Monitor, Multi-Display System, or Text-Only Terminal
NOTE: Use of the (B) port requires that VME Services software be installed in the
kernel under HP-UX. The (B) port is not supported during "cold installs" of
HP-UX because VME Services is not installed in the "install kernel".
Figure 4-3

Connecting a Terminal to the RS-232 Ports

2 Plug the standard end of the conversion cable into the appropriate connec-
tor of RS-232 serial cable HP 24525G.
3 Plug the other end of the serial cable into the serial connector on the ter-
minal.
Once you have connected and powered on your terminal and board com-
puter, you may need to reconfigure your board computer for the terminal to
be the console (see Appendix A).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Cables
RS-232 (A)
RS-232 (B)
4-7