Table of Contents
Advertisement
Operating the Traction
Control
To move the machine forward, squeeze the traction
control toward the hand grip
To move the machine rearward, push the thumb pad
down to move the traction control away from the hand
grip
(Figure
12).
The more you move the traction control in either
direction, the faster the machine moves in that
direction.
To disengage the traction drive, release the traction
control.
Figure 12
1. Traction control
Operating the
Blade-Control Clutch
This machine is capable of cutting brush and saplings
up to 1.8 m (6 feet) tall and 5.1 cm (2 inches) in
diameter. The cutting deck pivots to follow the contour
of the ground as you move the machine.
To engage the blade, use your right hand to open the
safety latch and then use your left hand to squeeze
the blade-control clutch to the left handle
To disengage the blade, release the blade-control
clutch.
(Figure
12).
g186864
2. Thumb pad
(Figure
12).
After Operation
After Operation Safety
General Safety
•
Clean grass and debris from the machine to help
prevent fires. Clean up oil or fuel spills.
•
Shut off the engine, and remove the key. Wait
for all movement to stop and allow the machine
to cool before cleaning, adjusting, repairing, or
storing the machine in any enclosure.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Hauling Safety
•
Remove the ignition key (if equipped) before
loading the machine for hauling.
•
Use care when loading or unloading the machine.
•
Secure the machine from rolling.
13
Figure 13
g188811
Advertisement
Table of Contents
