Adjusting The Traction Drive For Neutral - Toro Groundsmaster 7210 Series Operator's Manual

2
1
Figure 77
1. Bolt
2. Control panel
4. Move the control lever to the N
but not locked (Figure
5. Pull the lever back until the clevis pin (on an
arm above the pivot shaft) contacts the end of
the slot (just beginning to put pressure on the
spring) as shown in
Figure 78
1. Clevis pin
2. Slot
3. Jam nut
6. Check where the control lever is relative to notch
in the console (Figure
Note:
The control lever should be centered,
allowing lever to pivot outward to the
N - position.
EUTRAL LOCK
G020875
position
EUTRAL
79).
Figure 78.
4. Adjustment bolt
5. Yoke
79).
g020875
1. N position
EUTRAL
7. If adjustment is needed, loosen the nut and jam
nut against the yoke
8. Applying slight rearward pressure on the
motion-control lever, turn the head of the
adjustment bolt in the appropriate direction until
the control lever is centered in the N
position (Figure
Note:
Rearward pressure on the lever keeps
the pin at the end of the slot and allow the
adjustment bolt to move the lever to the
appropriate position.
9. Tighten the nut and jam nut
10. Repeat steps
lever.
11. Install the front panel.
Adjusting the Traction
g004651
Drive for Neutral
Make this adjustment with the drive wheels turning.
DANGER
Mechanical or hydraulic jacks may fail to
support the machine and cause a serious
injury.
• Use jack stands when supporting the
machine.
• Do not use hydraulic jacks.
56
Figure 79
2. N -
EUTRAL LOCK
(Figure 78).
EUTRAL
78).
(Figure 78).
4 through 9 for the other control
g004918
position
-
LOCK