Presentation; Drill Motor And Stand; Drill Motor Dms160; Stand Dms160 - Husqvarna DMS 160 A Operator's Manual

Drill motor and stand

It is our wish that you will be satisfied with your product and
that it will be your companion for a long time. Think of this
operator's manual as a valuable document. By following its'
content (using, service, maintenance etc) the life span and
the second-hand value of the machine can be extended. If
you will sell this machine, make sure that the buyer will get the
operator's manual.
A purchase of one of our products gives you access to
professional help with repairs and services whenever this
may be necessary. If the retailer who sells your machine is not
one of our authorised dealers, ask him for the address of your
nearest service workshop.
Husqvarna Construction Products has a policy of continuous
product development. Husqvarna reserves the right to modify
the design and appearance of products without prior notice
and without further obligation introduce design modifications.

Drill motor DMS160

• DMS160 is an electric drill, intended for drilling concrete,
brick and various stone materials.
• The drilling machine has a modular design and is easy to
assemble.
• The machine has a speed range for drill bits with a
diameter(ø) of 120 mm / 4.75 In.
• The design of the slip clutch (SMC- Slide Mechanical
Clutch) gives the greatest power output and it can be
adjusted from outside.
• The machine is intended for stand mounted drilling.
• The machine is water cooled.
• The machine is double insulated and has power
indicators.
• The machine works at its best if not overloaded, let the
maximum yellow LED on the load/power indicator (LCS-
Load Control System) be on. Max. 10 minutes max. load
the machine must then be run without a load for 2 minutes.
8 –
English

PRESENTATION

Stand DMS160

DMS160 A/AT
The stands are secured using expanding screws.
• A water collector and vacuum plate are available as
accessories to suck the stand into place.
DMS160 AT
• DMS160 AT has a modular design that permits angle
drilling and a rotation function.
DMS160 Gyro
• DMS160 Gyro has a modular design with telescopic stand
to secure the drill motor.
• The telescopic support column has a maximum length of
3.1 metres, but can be extended an additional 0.75 metres
using an extension module.
• A maximum of one extension module may be used.
• Only one spanner (24/30 mm) and an allen key (8 mm)
are required to change the settings.
The drill column can be variably adjusted through 360°.
• The transport wheels can be removed.
DMS160 A DMS160 AT DMS160 Gyro