Assembly; Assembling The Stand - Dms160 A/At; Assembling The Stand - Dms160 Gyro - Husqvarna DMS 160 A Operator's Manual

Assembling the stand - DMS160 A/
AT
DMS160 A/AT
• Drill holes (15 mm) in the floor or in the wall and knock in
the expander bolts.
20 Bolt down the base plate. Check carefully that the
expander is secured correctly.
DMS160 AT
• The drill column is mounted on the base plate's angle
bracket. Tighten the lock screw with an 8 mm allen key.
The drill column can be turned through 360° and locked
variably in each position using a locking screw (8 mm allen
key)
• The drill column is set at the required angle by tightening
the nut using a 24 mm spanner. If the vacuum plate is
used, make sure the support surface is not porous and
can loosen from the floor or the wall. Make sure that the
vacuum pump has sufficient power to secure the vacuum
plate. A suitable vacuum motor is Husqvarna VP200.
WARNING! The vacuum plate must never be
!
used for ceiling drilling. Careless or
incorrect use can result in serious or fatal
injury to the operator or others.

ASSEMBLY

Assembling the stand - DMS160
Gyro
5
2
3
1
7
6
8
9
11
DMS 160 Gyro
4
10
– 9
English