Table of Contents
Advertisement
Chapter 2: Installation
Approved GE Security SFP Transceivers
GE Security Industrial Switch supports both Single mode and Multi-mode SFP
transceiver. The following list of approved GE Security SFP transceivers is correct at
the time of publication:
o SFP1000SX-220 SFP (1000Base-SX SFP transceiver / Multi-mode / 850nm /
220m~550m)
o SFP1000LX-10Km SFP (1000Base-LX SFP transceiver / Single mode / 1310nm /
10km)
o SFP100FX1310-TSC-2Km SFP (100Base-FX SFP transceiver / Multi-mode /
1310nm / 2km)
o SFP100FX1310-TSC-20Km SFP (100Base-FX SFP transceiver / Single mode /
1310nm / 20km)
NOTE:
We recommend using GE Security SFPs on the Managed Industrial Switch. If
you insert a SFP transceiver that is not supported, the Managed Industrial Switch will
not recognize it.
Before connecting the other switches, workstation or Media Converter:
1. Make sure both side of the SFP transceiver are with the same media type, for
example: 1000Base-SX to 1000Base-SX, 1000Bas-LX to 1000Base-LX.
2. Check the fiber-optic cable type match the SFP transceiver model.
o To connect to 1000Base-SX SFP transceiver, use the Multi-mode fiber cable-
with one side must be male duplex LC connector type.
o To connect to 1000Base-LX SFP transceiver, use the Single-mode fiber cable-
with one side must be male duplex LC connector type.
• Connect the fiber cable
1. Attach the duplex LC connector on the network cable into the SFP transceiver.
2. Connect the other end of the cable to a device - switches with SFP installed, fiber
NIC on a workstation or a Media Converter.
3. Check the LNK/ACT LED of the SFP slot on the front of the Managed Industrial
Switch. Ensure that the SFP transceiver is operating correctly.
4. Check the Link mode of the SFP port if the link failed. Co works with some fiber-NICs
or Media Converters, set the Link mode to "1000 Force" is needed.
30
GE-DSH-73/DSH-82 and DSH-82-PoE User Manual
Advertisement
Table of Contents
