Table 4-1. Operational Verification Descriptions - HP 10811A Operating & Service Manual

1. Amplitude (0.55 volts (±0.05 volts/50Ω, 1 volt ± 0.2 volt/1kΩ).
a. Equipment required:
BNC-to-BNC Cable
500 and 1 KΩ loads
3406A AC Voltmeter
2. Harmonic Distortion (-25 dB below 10 MHz output signal).
a. Equipment required:
141T Display Section
8553B Spectrum Analyzer - RF Section
8552B Spectrum Analyzer - IF Section
BNC-to-BNC Cable
3. Spurious Signals - Signals unrelated to the 10 MHz output signal (-100 dB below the 10 MHz
output signal).
4.
a. Equipment required:
141T Display Section
8553B Spectrum Analyzer - RF Section 8552B
Spectrum Analyzer - IF Section
BNC-to-BNC Cable
5. Short Term Stability (5 X 10
a. Equipment required:
5065A Rubidium Vapor Frequency Standard
5061A Option 004, or 105A/B, See
HP Model 5390A may be used in place of the following:
10830A Mixer
5345A Electronic Frequency Counter with Option 011
9825A Calculator with 98210A and 98213A or 98214A or 98216A
98034A HP-IB Interface
10515A Doubler
6-Plug AC Power Strip 3
BNC-to-BNC Cables
6. Long Term Stability -<5 X 10
a. Equipment required:
HP 1740A 100 MHz Oscilloscope,
105A/B Quartz Crystal Oscillator,
5065A Rubidium Frequency Standard, or 5061A Cesium Beam Frequency Standard.
See
Table
4-11. In the following tests, the power supply voltages to the oscillator are not shown. They are
assumed to be:
Oscillator Circuits ........................................ +12V dc
Oven Circuits ............................................... +20V dc
4-12. Any supply voltages within the specified limits listed in
the operational verification. The voltages are only reference points and are used throughout this
manual.

Table 4-1. Operational Verification Descriptions

Due to the complexity of measuring signal 100 dB
below a reference, this procedure will verify that no
spurious signals exist greater than 65 dB below the
normal 10 MHz output signal.
-12
for 1-second averaging; 1 X 10
-10
over 24 hours; 1.5 X 10
1-2.
NOTE
-11
for 10811-60105).
Table 1-2
-9
/24 hours for 10811-60105.
Table 1-1 may be used and will not affect
Model 10811A/B
17