Installation; Operating Environment; Power Supply; Power Switch For Service (Control Panel) - Sony BKDS-7017 Installation Manual

1-1. Operating Environment

. Install the unit in a well ventilated place to prevent a
temperature rise in the unit. Never cover the ventilation
holes of the outer frame.
. Never install the unit near a heat source because the
environmental temperature during operation should be
5 dC to 40 dC.

1-2. Power Supply

1-2-1. Power Switch for Service
(Control panel)
w
The power switches for service of the control panels are
placed only in the unit.
When installing the unit, incorporate a readily accessible
disconnect device in the fixed wiring, so that the operator/
engineer power in case a fault should occur.

1-2-2. Power Specifications

Power requirements : 100 to 240 V AC ± 10%
50/60 Hz
Current consumption
DVS-7150 : 4 to 2 A

BKDS-7017

: 1.0 A (max.)
m
As the inrush current at turn-on is the maximum 20 A, the
capacity of the AC power must be commensurate in it with
the inrush current of the maximum 20 A for the processor
and the control panel respectively. If the capacity of the
AC power is not the adequately large, the breaker of the
AC power at the supply side will operate or the unit will
abnormal operate.
DVS-7150E IM
Section 1

Installation

1-2-3. Power Cord

w
The power cords are not supplied with DVS-7150 and the
control panel. Be sure to use the power cords that are
applicable to the places in the world.
To avoid a fire or an electric shock, be sure to use the
designated power cord. And do not damage to the power
cord.
For the customer in the U.S.A. and Canada
Required Parts
1 Power Cord, 125 V 10 A (2.4 m) : 1-557-377-11
For the customer in the United Kingdom
Required Parts
DK-2401 (EK)
1 Power Cord, 250 V 10 A (2.4 m)
For the customer in the all European countries
except the United Kingdom
Required Parts
DK-2401 (AE)
1 Power Cord, 250 V 10 A (2.4 m)
n
For the customer outside of the area as shown above,
please consult with local Sony's sale/service office.
1
1
1
AC inlet
AC inlet
AC inlet
1-1