Option Board Installing/Removing; Procedures - Sony SR-R1000 Installation Manual

1-14-2. Option Board Installing/Removing

Procedures

SRK-R201 (ENC-134 board) and SRK-R202 (DEC-176
board) can be installed into Port A to Port D of the
SR-R1000 according to "1-14-1. Combination of Option
Boards."
A card board insertion/removal tool (Part number:
J-7120-800-A) is required to remove the DEC-176 board
that was installed in Port D when the SR-R1000 was
shipped or to remove option boards that were installed
according to "Installation" in this section. Remove the
DEC-176 board and option boards according to "Removal"
in this section..
n
Before installing a board, be sure to turn off the power
switch on the rear of the SR-R1000 and disconnect the
power cable. Failure to do so may cause electric shock or
damage to the board.
SR-R1000 rear SR-R1000 rear
Installation
The following describe a procedure to install the
SRK-R201 (ENC-134 board) into Port A. This procedure
also applies when installing a board into another port.
SR-R1000
1. Turn off the power switch on the rear of the SR-R1000
2. Remove the two screws to detach the blank panel.
PSW3 x 6 PSW3 x 6
3. Insert the ENC-134 board along the guide rails of Port
4. Push portions A of the board panel fully until the right
5. Match the screw holes of the SR-R1000 and the board
Power Power
switch switch
PSW3 x 6 PSW3 x 6
2 2
6. Perform the VERSION INFORMATION menu to
and disconnect the power cable from the power outlet.
n
Keep the removed blank panel in a safe place.
A.
and left parts of the board panel contact the SR-R1000
unit.
n
Do not push the BNC connector, but push the panel
(portions A) to insert the board.
panel and tighten the two screws removed in step 2
(fi rst screw 1 and then screw 2).
Guide rails Guide rails
Portions A Portions A
PSW3 x 6 1 PSW3 x 6 1
confi rm that the option board has been recognized.
(Refer to Section 1-14-3.)
Blank panel Blank panel
1-23 (E)