eBABYHR DIGITAL BABY HEIGHT ROD
1
Slide open the battery compartment next to
the digital display. Insert 2 AAA batteries and
replace compartment cover.
5
Place the baby on a flat surface. Position the non-moving
panel at the baby's head. Stretch the baby's legs and slide
the measuring panel towards the baby's feet.
7
UNIT
To view the height in another measuring unit,
press UNIT.
• To prevent patient injury, the patient must be attended throughout the
entire weighing event. • Clean all external surfaces with a clean damp cloth.
• Do not immerse the product into cleaning solutions or water. • Do not use
abrasive cleaners. • Do not spray the product with liquid. • In no event
whatsoever shall Pelstar, LLC / Health o meter® Professional Scales be liable
for damages or injuries arising out of or connected with the assembly, use,
or misuse of its products.
P/N UMeBABYHR_REV20180723
2
3
ON/OFF
Slide the measuring panel all the
To turn on the digital
display, press ON/OFF.
way in towards the digital display.
6
DIGITAL
Gently align the measuring panel at the soles of the baby's
feet and read the height on the display.
8
HOLD
To hold the height on the screen, press HOLD. To
release the height, press HOLD again.
4
min = 35 cm
Press RESET to set the height
reference point at 35 cm. This
step must be done each time the
height rod is powered on.
cm
feet/inch
ANALOG
HOLD OFF
RESET
min = 35 cm /
13.78
inches
max = 80,1 cm /
31.54
inches
www.homscales.com