Advertisement
7. Insert the GPS-SS harness in the direction of arrow A.
(Fig.1)
n
Do not pull the GPS-SS harness completely out.
8. Insert the claw of the F cover bracket into the hole of
the handle assembly.
9. Place the module clamp on the F cover bracket and
secure it with the precision screw (P2.6 x 5) that is
removed in step 3.
n
When the module clamp is placed, be careful not to
pinch the coaxial cable and GPS-SS harness between
the module clamp and the handle assembly.
10. Pass the coaxial cable of the CN connector RF cable
assembly through the square hole of the GPS handle
plate. Then reinstall the CN connector RF cable
assembly in the GPS handle plate with the two preci-
sion screws (P2.6 x 10). (Fig.2)
11. Insert the coaxial cable of the CN connector RF cable
assembly in the direction of arrow B. (Fig.1)
n
The GPS-SS harness and coaxial cable must be located
at the positions shown in Fig.1 when viewed from the
top of the handle assembly.
HKDW-704
1-10. Wiring Cables to the Handle Assembly
When viewed from the top
Fig.1
Coaxial cable
B
A
Do not pull the
GPS-SS harness
GPS-SS harness
completely out so
that a part of the
harness is left inside.
Module clamp
F cover bracket
Coaxial cable
B
CN connector
RF cable assembly
When viewed
GPS Handle plate
from the front
CN connector RF
cable assembly
Precision
screws
P2.6 x 10
Handle
assembly
Precision
screw
P2.6 x 5
Handle
Claws
assembly
Hole
A
GPS-SS
harness
Fig.2
Square hole
Coaxial cable
1-11 (E)
Advertisement
