Advertisement
1-11. Installing the GPS Module
1-12. Installing the GPS Antenna
9. Insert the coaxial cable of the CN connector RF cable
assembly into the handle assembly and secure it with
the three screws (screws that were removed in step 2 in
Section 1-10).
n
When reinstalling the CN connector RF cable assem-
bly in the handle assembly, be careful not to pinch the
GPS-SS harness and the coaxial cable between the CN
connector RF cable and the handle assembly.
Handle assembly
Coaxial cable
CN connector
RF cable
assembly
P2 x 4
10. Reinstall the VF slide assembly by reversing the steps
of removal. (Refer to step 1 in Section 1-10.)
1-14 (E)
1-12. Installing the GPS Antenna
Length of antenna is different in the GPS antenna (150)
and the GPS antenna (5000). Select appropriate length of
antenna depending on your application. The following
steps 1 and 2 are required only in the GPS antenna (150).
n
The GPS antenna (5000) contains the built-in magnet
instead of the GPS antenna tape.
1. Separate the GPS antenna tape into the two pieces and
peel off the exfoliation paper. Attach the tapes to the
positions shown by the dotted lines of the GPS antenna
(150) and the viewfinder.
2. Attach the GPS antenna (150) to the viewfinder.
3. Connect the GPS antenna connector to the CN connec-
tor.
GPS antenna (150)
Connector
GPS
antenna
tapes
Exfoliation paper
Hook (A)
(Hard)
GPS antenna
tapes
Loop (B)
(Soft)
Exfoliation paper
Viewfinder
CN connector
HKDW-704
Advertisement
