Advertisement
Wired Dimming Connections (Optional)
RISK OF ELECTRIC SHOCK
• Turn power off before installation, inspection, cleaning or removal.
And follow appropriate lock out/tag out safety procedure.
• This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and
operation of the product and the hazards involved.
Remove screws
1
Junction Box Cover Removal
•
Using a #1 Phillips screwdriver, unscrew the 6
screws on the junction box cover.
•
Remove the junction box cover from the
junction box enclosure.
NOTE: Be sure to hold on to the screws, junction
box cover, and gasket for future use.
Dimming
Switch
+ (0-10V)
- (0-10V)
3
Wire Dimming Electrical Connection
Connect the appropriate wiring to Dim + (0-10V)
and Dim - (0-10V) from driver. Insulate the
black, pink & blue wires. Follow dimming switch
instructions for rest of connection.
WARNING / AVERTISSEMENT
Remove cover
Driver
Black
Pink
Blue
Violet
Gray
RISQUE DE CHOC ELECTRIQUE
• Coupez l'alimentation avant l'inspection, l'installation ou la
désinstallation.
• Ce produit doit être installé selon le code d'installation
pertinent, par une personne qui connaît bien le produit et son
fonctionnement ainsi que les risques inhérents.
Insert
fitting
Dimming wires
2
Wall Dimming Wire Insertion
•
Remove the sealed gland in the top of
the junction box enclosure, and install an
appropriate Listed ½" NPT fitting rated for
the environment into the open threaded open
conduit connection.
•
Bring the conductors for the building dimming
network into this fitting.
NOTE: Customer is responsible for the 1/2'' NPT-
14 thread per inch fitting.
Gasket in cover
4
Junction Box Cover Replacement
•
Ensure gasket is sitting in place on the inner
edge of the junction box cover.
•
Fasten all 6 screws to ensure water tight seal.
NOTE: Be careful not to strip out the junction box
enclosure by over tightening the screws.
6
Advertisement
