Error Signs; Clock; Operating Instructions - Sanyo FXC-503LD Operating Instructions Manual

ERROR SIGNS

If a problem should occur while operating the CD changer, one of the folloying error signs may be
displayed.
Error Sign
E07
E30
NO CD
L Err
Note
When using FXLPC200, "E-07" is not displayed.

CLOCK

TIME DISPLAY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Press button 0 to display the time.
The time display appears for approximately 5 seconds.
ADJUSTING THE TIME . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
To adjust the time, press button Q or 0 while pressing button 0.
To adjust the hour, press button Q.
To adjust the minutes, press button 0.
If button Q or 0 is held while pressing button 0, the displayed time will advance rapidly.
CLOCK RESET.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 134
Press button @I while pressing and holding button 0 to skip to the nearest half-hour as follows.
Example: 3:00-3:29
Note
This unit uses a 12-hour clock.
l
Cause
I
The disc is inserted incorrectly.
Excessive temperature in the car is
detected.
The magazine is not fully inserted into
the changer.
There are no discs in the magazine.
The connector is detached.
Remedy
I
of ourchase.
Insert the disc properly.
Refer to the CD-Changer Operating
Instructions.
Allow the car to cool.
Then press the magazine eject button
on the CD changer unit.
Completely insert the magazine into
the changer until it clicks in place.
Insert discs into the magazine.
Properly connect the connector.
1
I