Throttle Opening Adjustment At Reverse; Remote Control Box For Twtn-Engtne; Storage - Yamaha 703 Instructions Manual

8.
1)
2)
THROTTLE OPENING
ADJUSTMENT AT REVERSE
Remove
the wire cover,
remove
the
screws,
and remove the rear
housing (uppefl and
back
panel(lower).
Loosen
the locknut, and adjust the throttle
by
turning the adjusting
bolt.
Turning
the adjust-
ing bolt to the left makes the throttle
opening
larger, and turning
it to the right
makes the
opening smaller.
lf
the reverse throttle opening is too large, it
may lead
to
an error in control operation.
Set
the remote control lever so that it does not turn
more than
60'to
the reverse.
1. Adjusting bolt
2.
Locknut
3)
After adjusting, tighten the adjusting bolt
and
locknut.
Adjusting bolt, Locknut:
4
Nm,0.4
kgf-m,
3.0|b-ft
4)
lnstall
both
rear houslng
(uppefl and back pan-
el (lower) with screw, and installthe
wire cover.
9.
REMOTE CONTROL BOX FOR
TW!N.ENGINE
For
twin-engine application, combine two
remote
control boxes using
the twin-attachment kit
(P/N:
703-48290-01
).
,..
*
..':;''''
....*
3
1. Screw
2.
Spacer
3.
Bulwark
4. Washer
5.
Nut
6. Remote control
box
1
O.
NOTE ON STORAGE
Follow
the instructions below when storing
the
re-
mote control box for a long period of time.
1)
Remove the cable
joints
and apply water-resist-
ant grease
(Yamaha grease A) to the threaded
portion
of
the
inner cable.
2)
Also apply water-resistant grease
(Yamaha
grease A)
to inner parts
of the remote
control
box, particularly to contact surfaces of
moving
parts. lf any rust is found, remove it and
apply
the grease (Yamaha grease A).
Avoid bending the cables into
a
loop
as
much
as possible. But if they have
to be
looped, the
loop diameter should be more
than
1
m (40
in).
Select a dry place for storage.
3)
4)
10