Table of Contents
Advertisement
6.
CHANGE
IN
THE REMOTE
CONTROL LEVER POSITION
This
remote control box can change
the
remote con-
trol
lever
to the opposite position as shown
below.
Besides,
the grip can
be changed
to
reverse. Follow
the procedure for repositioning.
A. Original
remote control lever position
B.
Repositioned remote
control
lever and grip
C.
Repositioned remote control lever
TIP
Steps 4), 6)
to 9),
11)
to
13)
are not
necessary
if
the
grip
is not repositioned.
1)
Pinch
fte
wire
cover
with your fingers, and
pull
it
out
to
remove.
2)
Using
a socket wrench (12 mm), loosen
the
bolt.
3)
Place a
puncfi
on
the bolt
head,
and
by
tapping
it with
a
hammer. remove
the
remote control
lever
from
the
rernote
control
box.
Use care
not
to
damage power
trim
and
tilt
switch leads.
4)
Remove
the
remote
control
lever
cover and
re-
move
the power trim and tilt switch leads
from
the guide of
the
remote control
lever.
5)
Remove two screws and neutral lock
holder.
6)
Remove the screw and neutral interlock trigger.
TIP
Make sure not to drop the spring.
7)
Remove
two screws and pull
the grip from
re-
mote control
lever.
1. Remote
control
lever
2.
Remote
control
lever cover
3.
Power
trim
and
tilt
switch leads
4.
Neutral lock holder
5.
Neutral interlock
trigger
6.
Grip
7.
Spring
8)
Reverse
the
grip
and
put it into
the
remote con-
trol
lever and
secure
it
with two screws.
9)
lnstall the neutral interlock trigger with
the
screw
10)
Reverse
the
remote
control
box and secure
lhe
neutral lock holder with two screws.
Screws
Grip screw:
3 Nm, 0.3
kgtm,
2.2 lb-ft
Neutral interlock trigger screw:
3 Nm, 0.3 kgf-m,
2.2|b-ft
Neutral lock holder screw:
4
Nm,0.4 kgtm,
3.01b-ft
11)
Align the
power
trim and tilt switch leads
at the
upper
taped position with the end of the
grip,
and the center taped position with the exit
of
the
spiralslit.
7
Hide quick links:
Advertisement
Table of Contents
