Operation; Connecting To A Power Source - Toro 51480A Operator's Manual

4
Adjusting the Trimmer
Height and Base Position
No Parts Required
Procedure
•
To adjust the auxiliary handle height, release the auxiliary
handle latch, slide the auxiliary handle up or down to the
desired height, then secure the auxiliary handle in place by
closing the auxiliary latch
1. Auxiliary handle
2. Auxiliary-handle latch
•
To adjust the trimmer height, open the height adjustment
latch, then slide the shaft up or down to desired height,
securing it in place with the latch
•
To adjust the position of the base, press down on the rotator
button located at the base of the shaft, then move the base
to face the desired direction
1. Rotator button
(Figure 4).
Figure 4
3. Height-adjustment latch
(Figure 4).
(Figure 5).
Figure 5

Operation

Connecting to a Power
Source
WARNING
If you do not fully seat the extension cord on the inlet
plug, the loose plug could lead to overheating and
cause a fire, possibly burning you or others.
Ensure that you fully seat the cord on the plug and use
the cord lock feature to secure the cord.
NOTICE! Do not use a damaged cord.
g015655
1. Inlet plug
2. Extension cord
g015683
6
Figure 6
3. Cord lock
g015693