Table of Contents
Advertisement
Pre-Maintenance
Procedures
Raising the Seat
Ensure that the parking brake is engaged. Lift the
seat forward.
You can access following components by raising the
seat:
•
Serial plate
•
Service decal
•
Seat-adjustment bolts (if applicable)
•
Fuel filter
•
Battery and battery cables
Lubrication
Greasing the Bearings
All Models without MyRide
Service Interval: Every 25 hours—Grease all
lubrication points (non-MyRide
models only).
Grease Type: No. 2 lithium grease
1.
Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Clean the grease fittings
37) with a rag.
Note:
Make sure to scrape any paint off the
front of the fitting(s).
1. Front caster tire
Located on the seat-pan underside
1. Read the instructions
before servicing or
performing maintenance.
2. Check the tire pressure
every 25 operating hours.
4.
Connect a grease gun to each fitting
and
Figure
37).
5.
Pump grease into the fittings until grease begins
to ooze out of the bearings.
37
EUTRAL
(Figure 36
and
Figure 36
Figure 37
3. Grease every 25 operating
hours.
4. Engine
(Figure 36
-L
OCK
Figure
g032432
decal106-8717
Hide quick links:
Advertisement
Table of Contents
