Advertisement
1.2.
LEAD PAINT WARNING!
Paint once contained lead as a traditional ingredient. Contact with the dust from the removal of such
paint is toxic and must therefore be avoided. The following action must be taken before using the cut-off tool.
1.
User must determine potential hazard relating to age of paint to be removed (modern paints
do not have lead content).
DANGER! Keep all people and pets away from the working area. The following are particularly
2.
vulnerable to the effects of lead paint dust: Pregnant women, babies and children.
3.
We recommend personal protection by using the following safety items:
a) Paint Spray Respirator (Our ref SSP1699)
b) PE Coated Hooded Coverall (Our ref SSP265).
4.
Take adequate measures to contain the paint dust, flakes and scrapings.
5.
Continue to wear safety equipment as in (3) above and thoroughly clean all areas when work
is complete. Ensure that paint waste is disposed of in sealed bags or containers according to
local regulations.
2.
INTRODUCTION & SPECIFICATION
Extended reach cut-off tool is especially suitable for cutting off rear axle and exhaust tubes/brackets. Additionally
suited to cutting off side frames or door sills. Fitted with metal safety guard and throttle safety device to prevent
accidental operation. Cutting disc not included.
Disc Size: ................................. Ø75 x 2 x Ø10mm
Free Speed:............................................20000rpm
Operating Pressure:....................................... 90psi
Air Consumption:........................................... 7cfm
Air Inlet:..................................................... 1/4"BSP
Weight:.......................................................... 0.8kg
Pressure Noise Level:............................ 97.6dB(A)
Power Noise Level:................................ 86.6dB(A)
Measured vibration emission value (a)....... 2.1m/s²
Uncertainty value (k)................................. 0.08m/s²
3.
PREPARING CUT-OFF TOOL
3.1.
Air Supply - Recommended hook-up is shown in fig 2.
3.1.1.
Ensure that the cut-off tool air valve (or throttle) is in the "off" position before connecting to the air
supply.
3.1.2.
You will require an air pressure between 70-90psi, and an air flow according to the specification above.
3.1.3.
Ensure the air supply is clean and does not exceed 90psi while operating the cut-off tool.
Too high an air pressure and/or unclean air will cause excessive wear, and may be dangerous,
causing damage and/or personal injury.
3.1.4.
Drain the air tank daily. Water in the air line will damage the cut-off tool and invalidate your warranty.
3.1.5.
Clean air inlet filter weekly.
3.1.6.
Line pressure should be increased to compensate for unusually long air hoses (over 8 metres).
The minimum hose diameter should be 1/4" I.D. and fittings must have the same inside dimensions.
3.1.7.
Keep hose away from heat, oil and sharp edges. Check hoses for wear, and make certain that all
connections are secure.
3.2.
Couplings
Vibration may cause failure if a quick change coupling is connected directly to the cut-off tool. To
prevent this, connect a leader hose - Sealey model number AH2R or AH2R/38 - to the cut-off tool. A
quick change coupling may then be used to connect the leader hose to the air line recoil hose. See fig.1
and fig.2.
fig. 1
© Jack Sealey Limited 2013
Pressed steel spanner:...........................................
Allen key: ........................................................5mm
Cutting disc:[not supplied] ............ (single) PTC/3C
Cutting discs:[not supplied]... (pack of 5) PTC/3C5
fig. 2
Original Language Version
c) Latex Gloves (Our ref SSP24).
SA2501 Issue: 1 -
14/05/13
Advertisement
