Commissioning The Expansion Module Pac Profinet (828D); Commissioning The Plc For Sentron Pac; Sinumerik 840D Sl; Commissioning The Plc With Profibus - Siemens SINUMERIK 840D sl Ctrl-Energy System Manual

3.1.4

Commissioning the expansion module PAC PROFINET (828D)

To communicate via PROFINET, the SENTRON SWITCHED ETHERNET PROFINET module
in combination with Sentron PAC3200/4200 must be parameterized differently.
1. Select SENTRON PAC "Settings" > "SWITCHED ETHERNET".
- OR -
Select SENTRON PAC "Settings" > "Expansion modules" > "MOD1" > "SWITCHED
ETHERNET".
2. Press "ENTER".
You obtain the following information in the subsequent window:
– Order number
– Serial number of the SENTRON SWITCHED ETHERNET PROFINET module
– Firmware version of the SENTRON SWITCHED ETHERNET PROFINET module
– The first character of the NameOfStation of the SENTRON SWITCHED ETHERNET
– IP-ADDR.:
3. Using the menu item "- ->", open the next window and obtain among other things the
information about the SUBNET address of the module.
Specifying/changing the device name
The device name can only be entered (it must be specified) using the powerconfig software
in the submenu "Expansion slot1".
● Sentron PAC3200: pac3200-pn22
● Sentron PAC4200: pac4200-pn21
The next time that the 828D boots, the 828D IO controller assigns the correct IP address to
the expansion module according to the device name:
● pac4200-pn21 --> 192.168.214.21
● pac3200-pn22 --> 192.168.214.22
3.2

Commissioning the PLC for SENTRON PAC

3.2.1

SINUMERIK 840D sl

3.2.1.1

Commissioning the PLC with PROFIBUS

PROFIBUS is commissioned with the PLC Toolbox 4.6 or higher.
Ctrl-Energy
System Manual, 01/2015, 6FC5397-0EP40-5BA2
PROFINET module that can be a maximum of 26 characters
The IP address of the module is displayed here.
3.2 Commissioning the PLC for SENTRON PAC
Ctrl-E Analysis
15