Siemens SIMATIC NET System Manual page 275

Functions
Depending on the properties of the addressed components and interfaces, the following
functions are available in the PST:
● Basic functions:
– Searching a network for devices with an Ethernet interface
– Calling up Web Based Management
– Downloading configurations to the components
– Using functions via the DOS command line
● Configuration for Industrial Ethernet / PROFINET
– Settings for IP addresses
● Configuration for PROFIBUS (for devices with Ethernet and PROFIBUS interfaces)
– Setting the PROFIBUS address
– PROFIBUS bus parameters
The PST provides these functions via a user-friendly user interface.
Requirements
● The devices have a preset ETHERNET (MAC) address or an IP address and can be
reached online in the network.
● PROFIBUS interfaces can also be configured using PST only for modules that also have
an accessible Ethernet interface in the network in addition to the PROFIBUS interface.
Supported operating systems
The Primary Setup Tool can be installed and executed under the following operating
systems:
● 32-bit operating systems
– Windows XP Professional SP2 and SP3
– Windows 7 Professional / Ultimate SP 1
– Windows 8.1 Professional
● 64-bit operating systems
– Windows 7 Professional / Ultimate SP1
– Windows Server 2008 Standard Server R2
– Windows 8.1 Professional
– Windows Server 2012 Standard R2
– Windows 10 Pro
– Windows 10 Pro Version 1607
Industrial Ethernet
System Manual, 09/2019, C79000-G8976-C242-10
SCALANCE network components
4.9 Network management software
275