Applications; Battery Removal/Installation; Charging - Hitachi DH 18DBL Handling Instructions Manual

APPLICATIONS

Rotation and hammering function
○ Drilling anchor holes
○ Drilling holes in concrete
○ Drilling holes in tile
Rotation only function
○ Drilling in steel or wood
(with optional accessories)
○ Tightening machine screws, wood screws
(with optional accessories)

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery
latches to remove the battery (see Fig. 3 and 4).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities
(see Fig. 4).

CHARGING

Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to the receptacle.
When connecting the plug of the charger to a receptacle, the pilot
lamp will blink in red (At 1- second intervals).
2. Insert the battery into the charger.
Firmly insert the battery into the charger as shown in Fig. 5.
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously in red.
When the battery becomes fully recharged, the pilot lamp will
blink in red. (At 1-second intervals) (See Table 2)
Hammering only function
○ Light-duty chiselling of concrete, groove
digging and edging.
Ventilation holes
Latch
Battery
33
English
Terminals
Battery cover
Fig. 3
Latch
Push
Battery
Pull out
Insert
Fig. 4
Battery
Pilot lamp
Charger
Fig. 5