Connecting The Power Wires; Connecting An Earth Ground Source - Toro 24 User Manual

Connecting the Power Wires

WARNING: All electrical components must meet applicable
national and local electrical codes including installation by
qualified personnel. These codes may require a means in the fixed
wiring of disconnecting AC power having a contact separation of
at least 0.120" (3mm) in the line and neutral poles. The wire used
for connection to the controller must have insulation rated at
105°C minimum. Do not connect the controller to one phase of a
3-phase power source. Ensure the AC power source is OFF prior
to connecting to the controller.
1. Ensure the power is discon-
nected at the source.
2.
Route the AC power and
equipment ground wires
through electrical conduit
to the controller.
3.
Remove the wiring access
panel located below the
transformer.
4. Using a small screwdriver,
secure wires as follows:
hot to L, neutral to N, and
equipment ground to
5. Reinstall the cover plate.
6. Apply power to controller.

Connecting an Earth Ground Source

!
Caution: Warranty may be void if the controller is not properly
grounded to an earth ground device.
1. Install a copper-clad ground device; i.e., 8' (2,5m) ground rod into
well moistened soil. The top of the rod buied at least 12" (30,5cm)
below grade.
2. Using a Cad-weld
6 AWG (10mm
to the controller in the most direct path. (Wire bends should be
minimal and not be less than 8" (20,3cm) in radius).
3.
Route ground wire through cabinet base using 1/4" (6mm) access
hole provided.
(continued)
.
(or equivalent) attachment method, connect a
TM
) solid copper wire to the ground device and route
2
Hot
Neutral
Equipment
Ground
73